coolsetr.blogg.se - Preventice beeping and screen lights up heart monitor

Check that the console wiring is securely connected to the circuit board.

Verify that there are no lights lit on the lower circuit board. CORRECTIVE ACTION: Reattach the connection securely if needed.

Locate the male-female connection between the console and mast.

Replace the console faceplate and replace the screws that hold the console electronics to the console housing.

CORRECTIVE ACTION: Reattach cable securely if needed.

Check that the console cable (a gray or black cable) is securely attached to the console circuit board.

From the top of the console, gently lift the console faceplate and electronics from the console housing.

Remove screws that hold the console electronics to the console housing.

Wait 60 seconds, allowing lower board to discharge built up energy. For easier adjustment bolt access, remove the end caps.

If you find the belt is slipping because it is too loose, center it then tension as needed. Repeat if necessary, until the belt remains centered during use. Use the motor cover marking or part line as a reference for alignment. If the running belt is too far to the left side: Using the supplied Allen wrench and with the treadmill running at 1 mph turn the LEFT adjustment bolt clockwise a ¼ turn and wait for the belt to adjust itself. If the running belt is too far to the right side: Using the supplied Allen wrench and with the treadmill running at 1 mph turn the LEFT adjustment bolt counter-clockwise a ¼ turn and wait for the belt to adjust itself. If your computer still isn't displaying anything on your monitor, proceed to Step 12. If your computer starts normally with only essential hardware installed, proceed to Step 11. Do not run belt faster than 1 mph and keep fingers, hair and clothing away from belt at all times. For example, disconnect peripheral devices that aren't necessary for your computer to work properly, such as USB-connected storage devices. A bar graph gives the user a relative signal quality indication. Resolution This issue can be resolved by aligning/centering and tensioning the running belt. Oxygen saturation and heart rate are displayed on the LCD screen.